DCL-200B无源触点扬州瑞浦

（图5）电动阀门安装示意图
特别提示
对于自备支架、联轴器的用户，请注意：
For the users who providing the support, shaft coupling by oneself. please note
支架、联轴器应由机械技术人员设计加工并应符合
（图6）的标注要求。
平行度不超过05m
Support, shaft coupling should be designed by the professional mechanical technical staff to process the requirement to marke ing that should also accord With( Fig. 6).n
联轴器两端轴孔的加工应必要的精度，尽可能消除转动间隙，以免阀门工作中出现回差
The processing of the both ends shaft hole of the sheft couping should guarantee the essential precision, dispel the interval of transmission as much as possible, in case that the difference that the appearance goes back in the valve wo
应严格联轴器两端轴孔的位置度，否则有可能超出执行机构设计的工作范围，导致因执行机构行程无法调整而使阀门C0再轴度不过中0．2mn不能正常工作
Should guarantee position degree of the both ends shaft hole of the shaft

执行器 电动头 电动阀门 电动装置 扬州