USB母座（双面插）贴板母座前两脚SMT板上母座PBT

STANDARD
ATMOSPHEIC
CONDITIONS
测试标准状度




UNLESS OTHERWISE SPECIFIED
THE STANDARD RANGE OF ATMOSPHERIC
CONDITIONS FOR MAKING MEASUREMENTS
AND TESTS ARE AS FOLLOWS:
(1) BETWEEN BODY AND CONDUCTOR: 5oC TO 35℃
(2) BETWEEN CONDUCTORS NOT TO BE CONTACT：45% TO 85%
(3) PRESSURE：86Kpa TO 106Kpa
在没有的情况下测试温度、湿度、气压如下：
(1)温度为5℃~35℃
(2)湿度为45%~85%
(3)气压为86 Kpa~106Kpa
MECHANICAL（机械性能）
ITEM项目 TEST CONDITIONS测试条件 PERFORMANCE 规格
1
CONNECTION
FORCE
插入力度 MEASUREMENT SHALL BE MADE AFTER CONNECTING AND DISCONNECTING USING STANDARD PLUG GAUGE 3 TIMES。
依据标准的PLUG GAUGE做第3次拔插后测定 3~20N
DISCONNECTION
FORCE
拔出力度 MEASUREMENT SHALL BE MADE AFTER CONNECTING AND DISCONNECTING USING STANDARD PLUG GAUGE 3 TIMES。
依据标准的PLUG GAUGE做第3次拔插后测定 3~20N
2 TERMINAL
STRENGTH
端子强度 A STATIC LOAD OF 0.1N/m(1kgf/cm)SHALL BE APPLIED TO THE TIP OF THE TERMINAL FOR 1 MIN
IN ANY DIRECTION
向排脚先端的任意一个方向加1分钟0.1N/m(1kgf/cm)的力度. THERE SHALL BE NO DAMAGE
TO THE TERMINAL SUCH AS CRACKS, LOOSENESS OR PLAY ELECTRICAL ,AND MECHANICAL
CHARACTERISTICS SHALL BE SATISFIED
在排脚中没有裂开、松动等异常，满足于机械、电气性能
ELECTRICAL（电气性能）
ITEM项目 TEST CONDITIONS测试条件 PERFORMANCE规格
3.1 CONTACT
RESISTANCE
接触电阻 MEASURED AT SMALL CURRENT（100m A OR LESS）
1000Hz
在微小电流（100 m A）以下测试 ≤0.03Ω
3.2 INSULATION RESISTANCE
绝缘电阻 APPLY A VOLTAGE OF 500V DC FOR 1 MIN
TO FOLLOWING PORTIONS AFTER WHICH MEASUREMENT
SHALL BE MADE:
(1) BETWEEN BODY AND CONDUCTOR
(2) BETWEEN CONDUCTORS NOT TO BE CONTACT
(3) BETWEEN CONDUCTORS NOT TO BE WHEN PLUG IS INSERTED DC 500V 1 MIN
输入500V DC电压1分钟，按以下接触方法测试：
（1） 插座体与排脚之间
（2） 不接触的排脚之间
（3） 插头插入时不接触排脚之间 ≥100MΩ