美国银晶炮筒螺杆清洗剂塑机清洗供应

A、使用说明：1、用清洗剂喷湿约5次注射之塑料安机以下(4安机以下)。2、用手套或胶 袋混和。3、储料后1至2分钟，才把塑料射出（重复以下程序，勿连续射出）4、将料斗 清洁乾净，加入转色后所用新塑料，将之前余料射出后即可正常注塑。
B、特色：节省转色时间及胶料、清洁炭渍及保护螺桿，使用方便。
C、注意：勿让儿童取玩。如不慎入眼，应立即以清水沖洗。
警 告：使用前作小样测试而作出肯定。内含压力气体，勿让儿童玩耍，勿近火源使 用，勿挤压与碰撞，不可曝晒或燃烧，存放在 40℃ 以下阴凉、通风乾燥处。 A, instructions for use: 1, with the cleaning agent sprayed wet about 5 times the injection of plastic less than the following (4 below the machine). 2, use gloves or plastic bags. 3, after 1 to 2 minutes, only the plastic injection (repeat the following procedures, not continuous injection) 4, the hopper clean, adding to the color after the new plastic, the remaining material will be injected before the normal injection molding.B, features: to save the color time and plastic materials, clean carbon stains and protection of the screw, easy to use.C, attention: do not let children play. In case of contact with eyes, please rinse with water immediately.
Warning: to make sure the sample test before use. Containing gas under pressure, do not let the child play, not near the fire source, do not squeeze and collision, not exposure or burning, stored in 40 DEG C cool, ventilated and dry place.