钢筋成型弯箍机自动钢筋弯箍机双线箍筋机2021

2021年我公司钢筋成型弯箍机在原有的过硬基础上升级，利用气缸压紧，空气压缩机动力，更换钢筋加工直径不用更换其他，一键操作可设置。

自动钢筋弯箍机HH4-12S二号机型，采用双同步带设置，大功率，针对加工4-12mm圆钢和螺纹，可将对角箍筋1.3米内的套子一机成型，同时支持定制加工加筋。

双线箍筋机，公司自动数控钢筋弯箍机采用气动原理，进料机构结合设备，可单线，双线调直弯箍切断。同时公司还有“曲线型调直钢筋弯箍机”，针对加工4-13mm钢筋。

钢筋成型弯箍机参数:

支持加工异形箍筋，正反弯箍

支持小尺寸的加筋加工

箍筋尺寸小6公分

箍筋尺寸大130公分

数控系统采用PLC，可触摸操作。

产品针对地域均可发货

1.1.6 Good grounding

In order to ensure the normal operation of the control system, improve system reliability, and ensure the personal safety of the operator, all parts of the control system should be well grounded.

The ground wire of the system should ensure that the wire diameter is not less than 4 square millimeters, and the distance to the ground terminal should be shortened as much as possible.

The ground terminal (negative terminal) of DC 24V must be disconnected from the ground.

1.1.7 System protection

Keep the control system isolated from the external environment to prevent dust, dust, metal dust and other debris from entering the control system, which may cause the control system to work abnormally, damage system components, and reduce system life.

The LCD screen (fragile) of the control system should be protected: keep it away from sharp objects; prevent objects in the air from hitting the screen; do not use your fingers to point, gesture, or tap on the screen; when the screen is dusty and needs to be cleaned, ·Use a soft paper towel or cotton cloth to wipe gently.

1.1.6 良好接地

为了让控制系统正常工作、提高系统可靠性、操作者人身安全，控制系统的所有部 分均应良好接地。系统的地线应线径不小于 4 平方毫米，且尽量缩短与入地端的距离。

直流 24V 的地端（负端）需与大地断开。

1.1.7 系统的防护

保持控制系统与外部环境的隔离，以避免由于灰尘、粉尘、金属粉尘等杂物进入控制系统 内部而造成控制系统工作不正常、系统部件损坏、降低系统寿命等。

应防护好控制系统的液晶屏幕（易碎品）：使其远离尖锐物体；避免空中的物体撞到屏幕上 ; 不能用手指在屏幕上指点、比划、敲打；当屏幕有灰尘需要清洁时，应·用柔软的纸巾或棉布轻 轻擦除。